Laser metal cutting in Utah

Clean, repeatable profiles cut from steel, stainless and aluminum sheet for signs, panels, plates and small parts.

Flatbed cutting table with a thin steel sheet and cut out circles, arcs and leaf shapes stacked at the edge

From file to cut parts

Laser cutting turns a flat drawing into a flat part with crisp edges and fine detail. It is the first step in most of our signs, panels and plates, and it is also a service on its own for shops and builders who need cut blanks to finish themselves.

We cut from DXF, DWG, SVG or vector PDF files. Before cutting, we check the file for open shapes, doubled lines and details smaller than the metal thickness allows. Then we nest the parts on the sheet to keep scrap low and send you a short note if anything in the drawing needs your decision.

Thin detail, clean edges

The laser leaves a narrow cut, which is why fine patterns and small lettering are possible. Edges come off the table clean on most jobs, and parts that will be handled or shown get a light deburr before they leave. Tolerances depend on the metal and the part, so we confirm them in the quote rather than in a general promise.

For decorative patterns, we look closely at the bridges between openings. Thin bridges can warp from heat or bend in handling. Small changes to the pattern keep the panel flat and still give you the look you drew.

One piece or a stack

A single prototype is welcome, and so is a small batch. When you order the same part again, we keep the nested file so the next run starts quickly. Parts can leave as cut, or move on to bending, drilling, polishing or engraving in the same shop, so you deal with one bench instead of three suppliers.

For builders who finish parts themselves, we can leave the parts on small tabs so they stay in the sheet for shipping, or separate and bag them by part number. Tell us how you want them to arrive and we pack them that way.

Seen most in our guide under storefront signs, equipment plates.

Laser metal cutting questions answered

What file types can you cut from?

DXF and DWG work most smoothly. SVG and vector PDF work too. A dimensioned sketch is fine for simple shapes, and we draw it up for your approval.

Can you cut parts from my own sheet?

Sometimes. Tell us the metal and thickness and we confirm whether it suits our table before you bring it in.

What tolerances do you hold?

It depends on the metal, the thickness and the part. We look at the drawing and state the tolerances we can work to in the quote.

Can cut parts be finished too?

Yes. Parts can be brushed, polished, engraved or drilled before pickup, all in the same shop.

Plan your laser metal cutting order

Send the drawing, the logo file or a photo of the piece you want to match. A written quote follows the proof.