Decorative metalwork in Utah
Screens, wall pieces and accents for shops, restaurants, offices and hotel lobbies, made at our bench and handed to you finished and wrapped.

What we make
Decorative work is the part of a room people remember: a cut steel screen between a dining room and the host stand, a brass edged panel behind a reception desk, a row of layered arcs on a lobby wall. We make these pieces from flat sheet and bar stock, cut them, form the edges, join the parts that need joining and give every face the finish you chose.
Most of our decorative work starts with a designer, an architect's interior team or a business owner who already knows the feeling they want. Some clients send a finished drawing with every dimension. Others send a photo of a pattern they like and the size of the wall. Both are fine. We turn either one into a cut file and a short written scope before any metal is cut.
Patterns, edges and finishes
Patterns can be drawn from your brand, from the landscape, or from plain geometry. We check every pattern for bridges that are too thin to stay flat, for openings that would trap dust, and for how the piece will look from the side, where the light catches the edges. Small changes at this stage often make a panel calmer and stronger at the same time.
Finishes follow the room. Brushed steel and aluminum feel quiet and modern. Polished stainless and brass give a warm flash in low light. Blackened steel, darkened with heat and sealed with wax, reads soft and deep beside wood and leather. We keep a finished sample of each one at the shop so you can hold it before you decide.
How it leaves the shop
Every decorative piece leaves with its edges softened, its back side clean and the hanging points you asked for: drilled holes, welded studs, a cleat or a simple frame. We wrap finished faces, pad the corners and write the top edge on the paper so nobody has to guess. Your own team or the trade you choose puts it on the wall.
Seen most in our guide under lobby features.
Decorative metalwork questions answered
Can you work from a designer's drawing?
Yes. A vector file is the easiest start, but a dimensioned PDF or a clear sketch works too. We redraw what we need and send it back for your approval.
What is the largest panel you can make?
That depends on the sheet size and on how the piece will be handled. Large features are often split into sections that line up cleanly. We confirm the split in the quote.
Do you match a sample finish?
Send the sample or a good photo in daylight. We make a small finished square for you to compare before the full piece is done.
Will you hang the piece for us?
Our work ends at the shop door. Pieces leave with the hanging hardware prepared, and your own team or the trade you hire puts them up.
Plan your decorative metalwork order
Send the drawing, the logo file or a photo of the piece you want to match. A written quote follows the proof.

